Insert depth

[bandedbigsixpoints]

I have a DMM in acrylic and was wondering why my insert goes so far into the barrel. If I don't push it in almost to the loop groove you can hear the air escaping out of the sides. I just ask because all the other I see in cabelas and on here it is a quarter inch from being as deep as mine.

[GOOSEHANSON]

sure someone didn't swap out a TR insert...I don't have my calls here..outa town, I would mic them if I was home for you...joe

[feetdown20]

[quote="GOOSEHANSON"]sure someone didn't swap out a TR insert...I

plus 1, the insert should be showing the saver loop, and it sounds like it is a tr, instead of a dmm.

Can you post up a pic of the insert so we can see the bored end of it, that might help

[bandedbigsixpoints]

I can't post a pic because I.....just.....can't. I actually tried but couldn't get my comp. to recognize the USB blah blah blah. I have a TR and I put it's insert in the dmm and it looks like it is where it should be (according to other pics i've seen) I will send my calls into the shop to get tuned probably next week so maybe they can look at it and see.
Thanks y'all

[hoyt]

I GOT A DOUBLE AND A SINGLE DMM AND THE DOUBLE GOES IN THAT FAR NOT SURE WHY

[feetdown20]

the reed set up shouldn't have anything to do with your insert depth. the insert should be snug, not tight, and not loose.